Need to replace a faucet? Learn How Here!

How to Replace a Kitchen Faucet

 

Lots of beneficial suggestions and step-by-step suggestions on how to install a new cooking area faucet, consisting of how to prevent common problems

 

The hardest part of replacing a kitchen faucet is removing the old one. Unforeseen problems always pop up– rusty pipes, difficult-to-reach nuts and poor access to fittings. Otherwise, setting up a new kitchen faucet isn’t hard at all. Actually, the directions that feature your brand-new faucet are most likely all you’ll need to do that part of the job.

Disallowing unforeseen problems, you might be washing up under the faucet in an hour or two. In this article stroll you through a fundamental replacement procedure and tell you how to make it through those tough parts.

Chances are, you’ll need to make more than one journey to the hardware store for parts to discover how to replace a kitchen faucet, however to provide yourself a combating chance at finishing the task with one-stop shopping, consult this list. We’ll reveal you how to eliminate a kitchen faucet with the steps in this short article.

Shutoff valves Before you buy your new faucet (see “Selecting a Faucet” at the end of this how to replace a kitchen faucet post), take an appearance under the sink and make sure that there are shutoff valves feeding the faucet. If you do not have shutoff valves, include them. If you have them, verify that they’re in working order by switching on the cold and hot water at the faucet and shutting off the valves. If the faucet still drips, install brand-new ones. Most most likely you have 1/2-in. copper supply pipelines. If so, add easy-to-install solderless “compression fitting” valves (Photos 9 and 10) to your shopping list. If not, buy whichever valve type is suitable with your pipes.
Supply tubes: Next, determine the existing supply tubes and buy brand-new stainless steel– sleeved supply tubes (Photo 9). They’re developed to offer rupture-free service for many years and can be routed around barriers without kinking.
Basin wrench: Also purchase a basin wrench ($15; Photo 4). This weird little wrench is made particularly for getting rid of and installing those hard-to-reach fasteners that secure older faucet assemblies to the sink. (Newer faucets have plastic Wing-Nuts that can normally be loosened and tightened up by hand.) A basin wrench’s spring-loaded jaws pivot so you can either loosen up or tighten nuts in tight spaces.
If you need to eliminate drain lines to access the faucet, get a monkey wrench or slip-joint pliers (Photo 1). For cutting copper tubes, buy a traditional tubing cutter. But if your copper supply lines are within a few inches of the back of the cabinet, purchase an unique small tube cutter (Photo 3). You’ll also require a set of open-end wrenches for disconnecting and linking the water lines.

Prior to detaching the drain lines, take a photo or make a sketch of the layout to help you put all of it back together.

Leave a comment

Your email address will not be published.